Unical !DEA - Operating Instructions; Control Panel Layout and Functions; Summer;Winter Selector and Heating Temperature; Domestic Hot Water Temperature Control

4


KEY
A Pressure gauge
B Summer/WinterSelector+Room
heating temperature regulator
(request from ON-OFF thermostat)
C Domestichotwatertemperatureregulator
D Unblock/calibration/diagnosisbutton
E Information display
F Heating function active
G Domestichotwaterfunctionactive
I Block symbol
L Burner in operation symbol


Via this knob it is possible to se-
lect the operating mode:
Summer (domestic hot water pro-
duction only)
The knob in position
(Summer)
indicatesthatheatingisexcluded
and that the antifreeze function
stays active.
Winter (domestic hot water pro-
duction and heating temperature
adjustment).
Positioning theknobinthe eld
shown to the side, indicates that
theboilerisin"Winter"mode,and
adjusts the temperature of the
heating circuit water.
The adjustment is between min.
45°Candmax78°C.

regulator
Via this knob it is possible to ad-
just the domestic hot water inlet
temperature:
Positioning theknobin the eld
indicated at the side, adjusts the
DHWtemperature.
The adjustment is between min.
35°Candmax57°C.
®
0
1
2
3
4
bar
MAX
M
I
N
MAX
MIN
bar
service
E
A
D
D
B
C
E
A
bar
service
G
N
I
L
F
M
M Fault symbol
N Temperature of fault code indication
Attention! The adjustment refers to the
request from the ON-OFF thermostat.
The temperature requested through the
OT input (Open therm) must be set on
the Regola Facile (maximum heating
temperature) and it is independent from
theposition of the knob, except for
“Winter”modeenabling.
MAX
MIN
MAX
M
I
N
MAX
M
I
N
MAX
M
I
N
