Unical KON 100 - Page 34

34
PUMP OVERRUN - ( 2 )
Continue with the modication of parameters by pressing
the - (MINUS)
Repeat the operations A-B-C to change value
VALUE
FROM TO DEFAULT
1 min 10 min 5 min
Pump overrun time after DHW operation - ( 3 )
Continue with the modication of parameters by pressing
the - (MINUS)
Repeat the operations A-B-C to change value
VALUE
FROM TO DEFAULT
0 sec.  30 sec
CAPACITY TO FLOW-RATE RATIO - ( 5 )
Continue with the modication of parameters by pressing
the - (MINUS)
Repeat the operations A-B-C to change value
VALUE
FROM TO DEFAULT
20 100 99

Continue with the modication of parameters by pressing
the - (MINUS)
Repeat the operations A-B-C to change value
VALUE
FROM TO DEFAULT
0 1 0

Continue with the modication of parameters by pressing
the - (MINUS)
Repeat the operations A-B-C to change value
VALUE
FROM TO DEFAULT
0 % 99 % 40
RELAY PUMP BOILER COLLECTOR - ( 4 )
Continue with the modication of parameters by pressing
the - (MINUS)
Repeat the operations A-B-C to change value
VALUE
FROM TO DEFAULT
0 1 0