41
gasket between the distributor and heat
exchanger
DANGER!
It is absolutely necessary to replace the
gasket at any time the inspection or mainte-
nance is made on the burner.
When refitting the mixer tighten the nuts pro-
gressively and in crossed way, by using a dy-
namometric wrench adjusted at 10 Nm (1 kgm).
Remove the gas flange ‘’ A ‘’ from the mixer fan,
remove the 8 screws ‘’ B ‘’ burner plate and proce-
ed to clean the burner and heat exchanger body.
Gasket
Burner
To Next Page
Loading...
