SAFETY REGULATIONS15
69
5) Lubricate the truck in accordance with the lubrication chart.
6) Disconnect the battery plug.
Actions during storage
1) Charge the battery and check the cell electrolyte levels
about every second month.
Putting back into service after storage
1) Clean the truck.
2) Clean and charge the battery in accordance with Battery
changing page 22.
3) Check the gearbox and hydraulic oil levels.
4) Lubricate the truck in accordance with the lubrication chart.
5) Connect the battery plug.
6) Carry out a weekly inspection in accordance with Weekly
inspection page 41.
WARNING!
The truck should only be put back into service by an
authorised service technician.
Taking the truck out of service
If the truck is out of action and cannot be operated from the
driver's seat using normal driving controls, contact the
supervisor immediately.
In consultation with an authorised service organisation, the
supervisor must make sure that the move can take place in a
controlled manner, so that there is no risk of accident. The truck
is moved using another truck of sufficient capacity to a suitable
place where the repair can take place. The truck must be lifted
using the specified lift points, see When lifting the truck page
66.
WARNING!
Ensure that the truck cannot fall over or slide off the
forks while being moved.
Swinging loads
The truck is not equipped to handle hanging loads that may
start to swing.
Installing the fire extinguisher
The fire extinguisher is to be installed in a suitable location so
that it is easily accessible without interfering with the view or
becoming a collision hazard in the case, for example, of severe
braking.
WARNING!
It is not permitted to drill into the overhead guard
pillars or the overhead guard itself.
Instruction Handbook PLL, PLE, PSL, PSD, PS, PSH, PLP, TS — D002652, B, GBR, ForTranslation
To Next Page
Loading...