Unicla UP-150 - Assembly of Body Continued

12.
Assembly of the body - continued
IV. Inspection, tightening and clearance of the rear cap
Tools required: • Torque wrench • Hexagon socket 6mm
• Thickness guage
Procedure: Tension the M8 Hexagonal ange bolts (4pcs)
diagonally, alternately and carefully. Check the rear cap
clearance as specied: 0.2≤ Gap ≤0.6mm
Tightening torque: 14.7 ±1 N•m
V. Installation of lipseal (Refer to page 9 for instructions)
VI. Test working assembly rotation
Tools required: • Shaft rotating handle
Procedure: Install the handle into the front section to check
the shaft rotates smoothly.
VII. Filling compressor oil
Procedure: Fill the following amount of oil into the drain
hole as shown in the photo.
Ensure drain is correctly plugged.
Standard oil type: Unidap 7 (PAG) or Unidap 3 (POE)
Amount of oil:
UP150/170 = 160±10 cc
UP90/120 = 140±10 cc
VIII. Drain plug
Procedure: Tighten drain plug.
Tightening torque: 11.7 ±1 N•m
Gasket
Valve
plate
Suction
plate
Torque
wrench
Socket
Thickness gauge
Shaft
rotating
handle
0.2≤ Gap≤0.6mm