Need help?Do you have a question about the Unico M4860 and is the answer not in the manual?
General| Model Number | M4860 |
|---|---|
| Cooling Capacity | 48, 000 BTU/H |
| Phase | 1 |
| Fan Motor HP | 1.5 HP |
| Weight | 250 lbs |
| Airflow | 1600 CFM |
| Voltage | 208/230V |
Recommended temperature range for the EC motor to ensure maximum service life.
Absolute temperature limit for the EC motor and its impact on performance and lifespan.
Table showing normal and maximum operating temperature limits for the EC motor.
Critical warning against rotating cooling modules sideways to ensure proper drainage and prevent damage.
Details on connecting refrigerant lines, including liquid/vapor lines and adapter types.
Table specifying refrigerant line sizes and connection types for different outdoor units.
Procedure for installing the TXV on cooling coils for non-iSeries systems.
Critical warning for iSeries systems: do not install TXV indoors; it's located outdoors.
Specific procedures for connecting small tubes and distributor nuts for iSeries units.
Procedures for connecting refrigerant lines, including bulb placement, clamping, and line set connection.
Critical safety warning: disconnect electrical supply before wiring to prevent electrocution.
Caution against operating the blower under low static pressure or free discharge conditions to prevent motor overload.
Critical warning against venting refrigerant, emphasizing legal compliance and use of recovery devices.
Procedure for charging the system based on sub-cooling measurements during cooling mode.
Critical caution for handling the blower assembly to prevent wheel damage or imbalance.
To Next Page
