105
USING CLOSE CALL MODES
To Start Close Call Only Mode, press and hold Hold/ .
To Use Close Call while Scanning or Searching, press Hold/ to toggle Close Call
Priority, Close Call DND, or Off.
MANAGING CLOSE CALL HITS
In Close Call Only Mode
When the scanner detects a Close Call signal, ‘Close Call’ appears for the length of
time set in Close Call Pause (or until the signal is lost if longer).
The band number blinks under the band that the hit was found in.
The frequency is displayed for the (+) delay time set in Search/Close Call Options
(even if it’s gone).
To hold on a CC hit press Hold. Press Hold again to resume. See Close Call Hold
Mode.
To store a frequency press E/yes then see Storing a Displayed Frequency.
To cancel a CC hit turn the scroll control.
To toggle CC bands off or on press the number key for each band.
To toggle the lock out status of a frequency press L/O.
To view the last CC hit press Hold. Press Hold again to resume.
To toggle the attenuation on or off (for all bands) press Func then 7(att).
To toggle the modulation (for all bands) press E/yes then 9(mod).
To exit CC only press Scan/Srch.
While Scanning or Searching with Close Call Override set to On, when the
scanner detects a Close Call signal, the scanner overrides the current audio and
goes to the Close Call hit.
‘CC Found!’ and ‘Press Any Key’ appear for the length of time set in Close Call
Pause (or until the signal is lost if longer). If you do not press ‘Any Key’, the scanner
will return to scanning after ‘pause’ times out.
Press any key (except Hold) to listen to and display the frequency for the (+) delay
time set in Search/Close Call Options (even if it’s gone).
Quickly press Hold to stay on the frequency. Press Hold again to resume
While Scanning or Searching with Close Call Override set to Off, when the
scanner detects a Close Call signal, the scanner does not override the current audio.
To Next Page
Loading...
Need help?
General
