90
To toggle Intermediate Frequency Exchange on or off Hold and press Func then
4(ifx). Press Hold to resume.
To toggle the attenuator on or off pressFunc then 7(att). (Press and hold 7(att) for
global attenuation).
Notes: The search time changes depending on the search step size. The step
defaults to the default band step for the channel. ‘Att’ will not show in the
display when on unless in Function mode. If you manually set the mode to
NFM or FM, the scanner will not reliably detect signals that are modulated in
either FMB or WFM. Close Call, Priority ScCloasean, Weather Scan and GPS
functions do not work in Band Scope Mode.
SEARCH/CLOSE CALL OPTIONS MENU
These are the settings you should look at before you perform a quick search, close
call search, search and store, or close call auto store.
To Edit Search and Close Options, press Menu.
1. Scroll to ‘Srch/CloCall Opt’ and press E/yes.
2. Scroll to the options below and press E/yes.
3. Press Scan/Srch to return to scanning when done with editing.
Freq Lockouts Repeater Find Set Attenuator
Broadcast Screen Max Auto Store Set Audio AGC
Tone/Code Search Set Delay Time P25 Waiting Time
Freq Lockouts allows you to review locked out frequencies or unlock all frequencies
for Searching and Close Call search.
Note: You can also do this in search mode by pressing Func then pressing and
holding L/O.
Unlocking All Frequencies:
1. Scroll to ‘Freq Lockouts’ press Menu.
2. At ‘Unlock All’ press E/yes.
3. At ‘Confirm?’ press E/yes to save and exit.
4. Press Menu to return.
Reviewing Locked Out Frequencies:
A ‘T’ appears to the right of a frequency if it is temporarily locked out.
1. Scroll to ‘Rvw Search L/O’ and press E/yes. If no frequencies are locked out,
you see ‘Nothing Locked’.
To Next Page
Loading...
Need help?
General
