English - 5
To send DTMF tones during a call (e.g., for an automated response
system), press
*
to temporarily switch to tone dialing. When you hang up,
the phone automatically returns to pulse dialing.
Set Up the Accessory Handsets
Install and Charge the Battery
1. Unpack all handsets, battery packs, and battery covers.
If you need to remove a cover, press in on the
notch and slide the cover down and off.
2. Line up the battery connector with the jack
inside the handset; the connector only fits one
way.
3. Push the connector in until it clicks into place;
tug gently on the wires to make sure the battery is securely connected.
4. Replace the battery cover and slide it into place.
Connect the Charger
1. Use an AC adapter to connect the power jack on each charger to a
regular indoor (120V AC) power outlet.
2. Place each handset in a charger with the display facing forward. If the
display doesn’t light up, reseat the handset or connect the charger to a
different outlet.
# Charge all handsets completely (about 15 hours) before using.
Test the Connection
Pick up each handset and press
tAlK/flAsh
. You should hear a dial tone and
the display should say
Talk
.
If there is noise or static, see page 20 for tips on avoiding interference.
To Next Page
Loading...
Need help?
General
