To Next PageTo Next PageWhat to do if my Uniden LRD2200SWS signal strength meter registers, but no audio?
If your Uniden Radar Detector's signal strength meter registers but there is no audio, ensure that the City Mode is OFF for highway use. Additionally, increase the volume.
What to do if my Uniden LRD2200SWS does not operate (Power LED not on)?
If the power LED on your Uniden Radar Detector is not on, try the following: * Check the power cord to ensure the connectors are properly installed. * Make sure the ignition key is in the ON or accessory position. * Check and replace the fuse if it's out. * Verify power to the lighter socket. * Check for a vehicle electrical problem. * Ensure the volume control is in the ON position. * Clean the cigarette lighter socket.
Why is my Uniden LRD2200SWS's detection weak?
Weak detection on your Uniden Radar Detector could be due to a few reasons. First, check the angle of the unit to ensure it is pointed towards the horizon. Second, make sure the antenna or sensor is not obstructed. Relocate the unit away from any obstructions outside the windshield, such as a wiper blade, or window tint.
What to do if my Uniden LRD2200SWS Radar Detector beeps over bumps or rough road?
If your Uniden Radar Detector beeps over bumps or rough roads, ensure the power cord is securely connected at both ends. Also, try cleaning the cigarette lighter socket.
Why does my Uniden LRD2200SWS Radar Detector beep at the same location?
If your Uniden Radar Detector beeps at the same location, it may be falsing because you have passed a motion sensor or alarm.
How to fix Uniden Radar Detector that bounces against the windshield?
If your Uniden Radar Detector bounces against the windshield, reposition it so that the bumpers are firmly against the windshield.
General| Laser Detection | Yes |
|---|---|
| City/Highway Modes | Yes |
| Voice Alerts | No |
| Safety Warning System (SWS) | Yes |
| Safety Camera Alerts | No |
| Auto Mute | Yes |
| Frequency Bands | X, K, Ka bands |
| Alerts | Audible, Visual |
| Power Source | 12V DC |
| Mounting Type | Windshield |
| Detection Bands | X, K, Ka, Laser |
Lists key features of the LRD 2200SWS radar detector.
Explains radar technology, bands (X, K, Ka), and detection.
Explains laser (LIDAR) technology, its narrow beam, and detection range.
Button to detach detector from mount.
Reduces X-band false alarms in urban areas.
Activates Audio Alert Only mode, dims LEDs.
Activates Auto Mute for reduced volume after initial alert.
Shows visual alerts, signal strength, and operation modes.
Powers the unit and adjusts audio alert volume.
Emits audio alerts with distinct tones for signal types.
Green LED indicates X-band radar presence and strength.
Amber LED indicates K-band radar presence and strength.
Yellow LED indicates Ka-SuperWideband radar presence and strength.
Red LED under L indicates laser signal presence.
Advice on mounting location and avoiding obstructions for optimal performance.
Instructions for adjusting the bracket for different windshield angles.
Steps to connect the unit directly to the vehicle's fuse box.
Instructions for connecting the unit via the cigarette lighter socket.
Details the self-test procedure upon powering up the unit.
Explains how to adjust the audio alert volume.
How to enable audio-only alerts and dim LEDs.
How the Auto Mute feature reduces alert volume during a warning.
How to use City Mode to filter false alarms in populated areas.
