What to do if my vehicle starts but the Uniden Radar Detector R1 does not turn on?
Verify that the power cord is securely connected to the unit and inserted into the cigarette lighter jack. You may also need to change the fuse in the power cord. Unscrew the cigarette lighter jack to access the fuse.
What to do if my Uniden R1 has no display or audio?
If there is no display, check the connections and ensure they are secure. If there is no audio, check if the Voice is turned off.
Why my Uniden Radar Detector R1 did not alert when a police car was in view?
The officer may not have radar/laser units turned on. Also, check that the band is turned on. Press MENU and cycle through the options to get to the bands. If the band is turned off, the OLED will show OFF. Turn the band on.
Why does my Uniden Radar Detector alarm briefly in the same location?
There may be a motion sensor or house alarm in use within range.
What to do if my Uniden R1 unit alarms when the vehicle hits bumps?
Check the connections and make sure they are all secure.
General| Model | R1 |
|---|---|
| Category | Radar Detector |
| Laser Detection | Yes |
| GPS | No |
| Display | OLED |
| Signal Strength Meter | Yes |
| City/Highway Modes | Yes |
| Auto Learn | No |
| Voice Alerts | Yes |
| Red Light and Speed Camera Alerts | No |
| 360° Protection | Yes |
| Auto Mute | Yes |
| Power Source | 12V DC |
| Radar Bands | X, K, Ka |
| Ka Band Frequencies | 33.4 GHz - 36.0 GHz |
| Detection Range | Long |
| False Alert Filtering | Ka Band Filter |
Details functions of VOL+, VOL-, MENU, MUTE/DIM, and CITY buttons.
Identification of components like Eagle Eye, USB port, and Audio Jack.
Details elements of the power cord, including MUTE button, LED, and USB port.
Instructions for mounting the R1 on windshield or dashboard.
Steps to turn on the R1 and its initial system check.
Configures Highway, City, Advanced modes and band sensitivities.
Manages voice alerts and Ka frequency announcements.
Options to turn specific radar and laser bands on or off.
Configuration for POP mode and filters for K/Ka bands.
Fine-tuning Ka band scanning and segmentation.
Controls display modes, color, and signal priority.
Customizes alert tones and auto mute functionality.
Settings for backlight, battery warning, self-test, and reset.
Steps to turn on the R1 and its automatic startup behavior.
Instructions for increasing or decreasing the unit's volume.
How to mute alarms and adjust display/key backlight brightness.
Switching sensitivity modes and guidance on updating firmware.
Explains Highway, City, and Advanced modes with band sensitivities.
Details POP mode for detecting fast radar bursts on K and Ka bands.
Explains SCAN display and how it indicates scanning progress.
How laser and radar signals are prioritized and displayed.
How multiple radar signals (threats) are displayed with priority.
How Auto Mute reduces alarm volume and its operational rules.
Basic cleaning and connection checks for the unit and cord.
Recommends periodic firmware updates and where to find them.
Addresses unit not turning on, no display/audio, false alarms, and brief alarms.
Troubleshooting no alerts with police in view and unit not turning on.
Details receiver, antenna, frequency, and physical specs.
FCC and Industry Canada compliance statements.
Covers warranty period, coverage, and invalidation conditions.
Instructions for packing and shipping a product for warranty service.
Lists trademarks associated with the product's technology.
To Next Page
