SPECIFICATIONS
General
Channels: Transmit: 54
Receive: 54
Controls: On/Off, Volume, Squelch
Status Indicators: TX, SCAN, , HI, LO, and
MEM,on LCD Panel
Channel Display: LCD (Dual 7 segment)
Selector Switch: Channel Selector switch
Buttons: LITE, 16, MEM, H/L, and STEP
Connectors: Antenna, remote speaker, and DC power
Size: 2 1/5"H x 6 2/5"W x 8"L
Weight: 2.4 lbs
Supply Voltage: 13.8V DC negative ground
Standard Accessories: Mounting bracket and hardware, DC power cord,
microphone hanger, spare fuse,remote speaker plug.
Antenna Impedance:
50Ω nominal
Microphone:
Rugged 1kΩ condenser mic element with
coiled cord
Speaker:
1.82 inch, 8Ω
Operating Temperature Range: –10°C~+55°C
Regulations: Type accepted underAS/NZS 4415:1996
Transmitter
Power Output: 1 watt or 25 watt (switch selectable)
Power Requirement: Not rated on LO;
25 watts output: 4.5A@13.8V DC
Modulation:
FM ±5 kHz deviation Max.
Hum and Noise Signal-to-Noise: 42 dB@300 HZ, 3kHz (nominal)
Audio Distortion: Less than 3% with 3 kHz deviation with 1000 Hz
modulating frequency (nominal)
Spurious Emmission: - 36dBm @ 25 Watts Max.
Output Power Stabilization: Built-in automatic level control (ALC)
Frequency Range: 156.025 to 157.425 MHz
Frequency Stability:
±1.58 kHz @ – 10°C to +55°C
Receiver
Frequency Range: 156.300 to 162.025 MHz
Sensitivity:
0.28µV for 20 dB SINAD
Circuit: Dual Conversion Super Heterodyne PLL
Squelch Sensitivity:
0.4µV Threshold
Spurious Response: 75 dB
Adjacent Channel Selectivity:
73dB @ 25KHz
Audio Output Power: 2.7watts (10% Distortion)
Power Requirement: 210mA @ 13.8V DC squelched
520mA @ 13.8V DC at maximum audio output
IF Frequencies: 1st -21.4 MHz
2nd - 455 kHz
±
9
To Next Page
Loading...
