Why I can't hear anything from Uniden MHS125 speaker?
If you can't hear anything from the speaker of your Uniden Marine Radio, the squelch level is likely too high. Adjust the squelch level to resolve this issue.
What to do if Uniden MHS125 won't transmit?
If your Uniden Marine Radio won't transmit, there are several potential causes and solutions: * Ensure you are not in weather or scan mode. * Verify you are not attempting to transmit on a receive-only channel or using the incorrect power level for the current channel. * Check the battery power level and charge it if it's low. * Make sure each transmission lasts less than 5 minutes.
What to do if Uniden MHS125 Marine Radio display flashes?
If the display on your Uniden Marine Radio flashes, it indicates that the radio is in a watch mode or scan mode. To stop the flashing, turn off scanning, Weather Alert Watch, Triple Watch, or Dual Watch.
Why Uniden Marine Radio charger power LED doesn't turn on?
The power LED on your Uniden Marine Radio charger might not turn on if the ambient temperature is below 0° C (32° F) or above 45° C (113° F). Do not use the charger under these conditions. Also, make sure the charging contacts on both the radio and charger are clean, and consider replacing the battery.
What to do if Uniden Marine Radio always emits noise?
If your Uniden Marine Radio is constantly emitting noise from the speaker, the squelch level is probably too low. You should adjust the squelch level.
What to do if Uniden MHS125 is not getting hazard alerts?
If you are not receiving hazard alerts on your Uniden Marine Radio, ensure that the Weather Alert Watch feature is turned on.
Why no one can hear me on Uniden MHS125?
If you can transmit using your Uniden Marine Radio, but no one can hear you, the area you are in might use different channel assignments. Check your UIC channel settings to ensure they are correct for your location.
General| Brand | Uniden |
|---|---|
| Model | MHS125 |
| Category | Marine Radio |
| Language | English |
Instructions for mounting the charger and charging the radio's battery.
Describes the radio's three main operating modes: Normal, Scan, and Weather.
Explains the four different watch modes: Weather Alert, Dual, Triple, and Quad Watch.
Instructions on activating, using, and managing channels in scan mode.
Explains how Triple or Dual Watch functions when the radio is in scan mode.
Describes simultaneous operation of Weather Alert and Triple/Dual Watch in scan mode.
Steps for initiating a transmission, including push-to-talk and microphone usage.
How to change the transmit power level from 1W to 2.5W or 5W for better range.
Information on legal operation, restrictions, and licensing for marine radio transmitters.
Essential rules and guidelines for using marine VHF radios, including channel monitoring.
Information on human exposure to radio frequency energy and compliance with safety standards.
Important warnings regarding the handling, charging, and disposal of the rechargeable Lithium Ion battery.
To Next Page
