Note:
1. If SCAN is deactivated while in an active channel, the UH-052XR will stay
on that active channel. If no other channels are active, the UH-052XR
will reinstate the starting channel.
2. Pressing [CTCSS] for 1.5 Secs. Will deactivate Open Scanning and
activate CTCSS Scanning.
3. Pressing [OS/GS] will switch to Group Scanning.
2. Group Scan (GS) Mode
Allows you to monitor a Priority Channel while scanning.
To use GS Mode Scanning, press the
[OS/GS]
key. GS icon appears on the display.
GS Scanning checks the Priority channel
activity regularly.
If the Priority channel becomes active the
radio will stay on that channel for as long
as the signal is present. If the received
signal ceases, Priority scanning continues
after 3 seconds.
If scanning stops on a channel which is not a Priority Channel UH-052XR
will continue monitoring the Priority Channel for activity while listening to
the active one.
To deactivate SCAN, press the [SCAN]
or [PTT].
Note:
1. If SCAN is deactivated while it is tuned to
an active channel, the UH-052XR will
stay on that active channel. If none of the channels are active, the UH-
052XR will reinstate the Priority channel.
2. If GS Scanning is initiated when there are no channels programmed in
GS memory, an error tone will be heard and scanning will not start.
3. Pressing [CTCSS] for 1.5 Secs. Will deactivate Group Scanning and
activate CTCSS Scanning.
4. Pressing [OS/GS] will switch to Open Scanning.
To Next Page
Loading...
Need help?
General
