The Microphone Hanger comes in two parts. How and where you mount
the MIC hanger will determine which parts to use.
Conventional Mounting with Screws
Use the front part of the MIC Hanger only.
Locate a suitable mounting position and mark and drill two 3mm holes.
Fix the MIC Hanger into place with screws.
Conventional Mounting with Double Sided Tape
Secure the front and back pieces of the MIC Hanger using the supplied
binding screws.
Locate a suitable mounting position.
Remove (peel off) the plastic covering the adhesive tape on the at area
of the MICHanger back piece and then press rmly to the mounting
position.
9
Mounting the MIC Hanger
UNIDEN UH6000 UHF CB Transceiver
To Next Page
Loading...
Need help?
General
