13
English
To turn Weather Alert Watch on or off, press and hold
CALL-MENU
while the radio is idle.
Select Setup and then WX Alert Mode. Use
CHANNEL UP
and
CHANNEL DOWN
to choose WX
Alert Mode setting
ON
or
OFF
.
Normal mode with Triple and Dual Watch
If you activate Triple Watch while operating in normal mode, the
radio checks channels 16 and 9 every two seconds; with Dual Watch
turned on, the radio only checks channel 16. The radio will not check
channels 16 or 9 while you are actively transmitting; it waits until
your transmission is finished and then checks the channels.
Press and hold
16/9-TRI
(on the radio or the microphone) for two
seconds to turn Triple/Dual Watch on or off. (To change between
Triple or Dual Watch, see page 18.)
Normal mode with both Weather Alert and Triple/Dual Watch
You can activate Weather Alert Watch and
Triple/ Dual Watch at the same time. The
radio performs both checks at their
scheduled time.
Scan mode
You can save channels into memory and
then use scan mode to monitor those
channels. When the radio detects a signal on
a channel, it pauses on that channel as long as the signal is received; when the transmission
stops, the radio will continue scanning.
In scan mode, you can get the following information from the display (some indicators will
not always be displayed).
wx
WX Alert : Every 7 seconds,
the radio checks the most
recently-used weather channel.
09
16
09
16
09
16
Triple Watch: Every 2 seconds,
the radio checks channels 9 & 16.
Monitoring Channel 25
wx
WX Alert : Every 7 seconds,
the radio checks the most
recently-used weather channel.
09
16
09
16
09
16
Triple Watch: Every 2 seconds,
the radio checks channels 9 & 16.
Monitoring Channel 25
11
1008 1312
17
15
20
14
The radio scans about
5 channels in 1 second.
When it detects a signal, the radio stays on the
channel until you press the CHANNEL UP button or the
signal stops.
Resume scan
11
1008 1312
17
15
20
14
The radio scans about
5 channels in 1 second.
When it detects a signal, the radio stays on the
channel until you press the CHANNEL UP button or the
signal stops.
Resume scan
To Next Page
Loading...
Need help?
General
