In TIME display mode, touch [MODE] repeatedly until the “ALARM” icon appears to show the alarm time.
To enable or disable the daily alarm, press [ALARM] repeatedly. Bell icon “ ” appears when alarm
is enabled.
Hold [ALARM] to enter alarm time setting mode. Press [+] or [-] to enter the desired Hr/ Min values
and press [ALARM] to conrm setting.
When alarm is going off, press [SNOOZE/LIGHT] button on the top of the unit to trigger snooze alarm
and the bell icon “ ” will ash indicating it is in the snooze mode. Press any other key to stop alarm for
one day.
Press [SNOOZE/LIGHT] for an extended backlight & projection
Press [LIGHT ON/OFF] to turn on or off the continuous backlight when adapter is connected
Low battery indication is available for the home unit itself and all of the 3 remote channels. Replace the
batteries and follow the setup procedure in this instruction manual.
Indoor Temperature: 0 C to + 50 C (+32 F to +122 F)
Outdoor Temperature: -40 C to +60 C (-34 F to +140 F)
In/Out Humidity : 20% - 99% RH
Radio frequency: 433 MHz
Quantity remote sensors: max. 3
Channel: 5
Transmission: up to 30M in open area, RF434 MHz
Temperature Resolution: 0.1 C
Humidity Resolution: 1 %
AC adaptor: ~ 220 V / 50 Hz, 6 V * 200 mA
Backup batteries: 1,5 V * 3 pcs. / АА
Remote sensor 1,5 V x 2 pcs / AAA.
To Next Page
Loading...