Page 6 For technical questions, please call 1-888-866-5797. Item 62976
Maintenance
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
1. Protect the Safe from moist or wet conditions.
Moisture may cause electronic damage in
the key pad or corrosion of the steel.
2. Occasionally wipe the safe and key pad clean with
a soft dry cloth or brush. Occasionally apply a small
amount of light oil or lock lubricant to the mechanical
lock mechanism. Be careful not to get any oil or
other liquids on or near the electronic mechanism.
3. Occasionally wipe the safe and Key Pad
clean with a soft dry cloth or brush.
Replacing the Batteries
1. If the Red Light illuminates the
Batteries need to be changed.
2. Follow the instructions for opening the Safe.
3. The Battery Compartment is located on the
inside of the Door. Gently slide the Battery
Cover off the Battery Compartment.
4. Remove used batteries.
Dispose of them properly or recycle them.
5. Insert four new “C” Batteries. Position batteries in
proper polarity and do not install batteries of different
types, charge levels, or capacities together.
6. Reinstall battery cover by placing it low against the
Battery Compartment and sliding it into place.
7. After changing the batteries, test the Code and
change it as needed before closing the Door.
Battery
Cover
Figure F: Battery Compartment
To Next Page
Loading...
