Page 6 For technical questions, please call 1-888-866-5797. Item 62983
Installation
Read the entire Important Safety Information section at the beginning of this document including all
text under subheadings therein before set up or use of this product.
WARNING
To prevent structural damage and possible collapse of the building, do not cut or alter
studs to fit the Safe. If the installation wall is a load bearing wall, professional
installation is required.
WARNING! Verify that installation surface has no
hidden utility lines before drilling or driving screws.
1. Choose location, then locate studs, 16" apart, with
a stud finder (not included). Mark stud locations.
2. Cut out small section of drywall next to stud,
then check inside for electrical wiring or
plumbing that might interfere with installation.
3. Measure back of Safe and transfer
measurements to wall.
4. Cut along marked lines and remove drywall.
5. Place Safe into hole, using shims if necessary.
6. Locate two mounting holes on each side.
7. Secure Safe with fasteners which are rated to
support the weight of the Safe and its contents.
To Next Page
Loading...
