MS120
Pen Scanner
The MS120 series bar code wands are targeted toward low
reading volume and cost effective solutions. The advanced
optics and electronic design convert bar code labels into a
high quality digital signal. Able to read color, faded and low
contrast barcodes quickly and accurately, the MS120 is a
proven solution.
The polished sapphire tip reduces wear on labels and is also
easily replaced if damaged. The MS120 is available with three
different interfaces. The MS120A is an undecoded model which
interfaces via a 9pin squeeze release connector. The MS120-
2 has an RS232 interface with a built in decoder. With a key-
board wedge (AT or PS/2) interface the MS120-3 also has a
built-in decoder
Its shape gives the MS120 the comfort and handling of a nor-
mal ink pen. Just sweep the tip of the wand across the bar
code in either direction and listen for the "good read" beep
that lets you know the data has been successfully captured. It
doesn't get any easier than that.
Features:
•Rugged, lightweight design.
•Easy to use and configure.
•Low power consumption.
•Wide read angle (0 ~ 45°).
•High scan speed (5 ~ 200 cm/sec).
•Durable, replaceable saphire tip.
•Keyboard wedge and RS232
interfaces available.
Scanners
To Next Page
Need help?
General
