-50- © 2017 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS650 User’s Manual
Example :
Set PREAMBLE String as “ ## ”
POSTAMBLE String as “ $$ ”
Setting Procedure:
Step 1 : Scan : CLEAR PRE/ POSTAMBLE.
Step 2 : Scan : PREAMBLE.
Step 3 : Scan : “ # ” twice from Full ASCII Table.
Step 4 : Scan : PREAMBLE.
Step 5 : Scan : POSTAMBLE.
Step 6 : Scan : “ $ ” twice from Full ASCII Table.
Step 7 : Scan : POSTAMBLE.
Data Format :
[Preamble] [Symbology ID] [Barcode Length] [Barcode Data] [Postamble]
[Terminator]
Notes:
1. A PREAMBLE is a string of up to 16 characters added to the beginning of a
scanned barcode.
2. A POSTAMBLE is a string of up to 16 characters added to the end of a
scanned barcode.
3. Default value for both: None.
To Next Page
Loading...
Need help?
General
