-55- © 2017 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS650 User’s Manual
4.6.1 Set ID – Setting Procedures
Steps:
1. Scan the SET ID bar code for a particular symbology.
2. Scan one or two alphanumeric characters from the Full ASCII
Table.
3. Scan the SET ID bar code again.
Example: Define the MSI Code ID = A, Code 93 = G9
MSI :
Step1: Scan MSI Set ID (Group 9).
Step2: “A” from Group 42.
Step3: Scan MSI Set ID (Group 9).
Code 93:
Step1: Scan Code 93 Set ID.
Step2: “G” from Group 56, Scan “9” from Group 46.
Step3: Scan Code 93 Set ID.
Notes:
1. The length of a Code ID is either one or two characters. If one
character is set, the Code ID output will be one character. If two
characters are set, the Code ID output will be two characters.
2. Only one type of Code ID will be sent.
To Next Page
Loading...
Need help?
General
