Unitech MS840 - Enter Mode; Default Settings; Factory Default; Good Read; Bad Read Indicators; Support Information

English
Deutsch
Español
Français
中文(简体)
中文(繁體)
日本語
영어
Quick Setup
Ver.1.1
http://www.ute.com/
(Continued from step 3 on page 1)
4.When pairing pin code is entered, scan the CR($M) barcode.
CR($M)
5.The scanner LED will be off and sound a short beep to confirm
successful pairing.
NOTE; Scanning the DLE($P) barcode will erase the entered link key
DLE($P)
※ In cradle mode, the cradle is set for functions
necessarily through SCM.
Scanner Mode
Trigger
Flash
UPC-E
Default
Cut Leading Digit
Send Check Digit
UPC-A Conversion
Display Version
Display Version
EAN-8
Default
Cut Leading Digit
Cut Check Digit
UPC-A
Default
Cut Leading Digit
Cut Check Digit
Scan Code
U.S.
Alt Key
EAN-13
Default
Cut Leading Digit
Cut Check Digit
ISBN Conversion
Beep
None
Medium
Code ID
No
Yes
Inter-Character Delay
1 ms
20 ms
Supplement Code
No
Yes
Terminator
Enter
Field Exit
Factory Default
Factory Default