Unitech MS851

-29- © 2019 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS851 User’s Manual
3.1.10 Decode UPC/EAN Supplemental
Redundancy
With Autodiscriminate UPC/EAN Supplementals selected, this option adjusts
the number of times a symbol without supplementals are decoded before
transmission. The range is from 2 to 30 times. Five or above is recommended
when decoding a mix of UPC/EAN symbols with and without supplementals,
and the autodiscriminate option is selected.
Scan the bar code below to select a decode redundancy value. Next scan two
numeric bar codes beginning on Appendix B. Single digit numbers must have
a leading zero. To change the selection or cancel an incorrect entry, scan
Cancel on Appendix B.
3.1.11 Transmit UPC-A Check Digit
Scan the appropriate bar code below to transmit the symbol with or without the
UPC-A check digit.