Unitech MS912+ - Warranty Policy

- 25 -- 26 -
MEMORY MODE
Default is comma ( , ) . You may replace it with any alphanumeric
characters from the full ASCII table in Full User’s Manual.
Example: To change Field Separator to Semicolon ( ; )
1. Scan [
Field Separator ]
2. Scan [ ; ] from the full ASCII table.
3. Scan [
Field Separator
]
. R010$
FIELD SEPARATOR
MEMORY MODE
Example: To set Date to 2022-08-01 (Year-Month-Day):
1. Scan [
Set Date ]
2. Scan [2], [2], [0], [8], [0], [1] on page 9 & 10.
3. Scan [
Set Date ]
Example: To set Time to 08:10:30 am (Hr:Min:Sec)
1. Scan [
Set Time
]
2. Scan [0], [8], [1], [0], [3], [0] on page 9 & 10.
3. Scan [
Set Time ]
. R006$
SET DATE
. R007$
SET TIME
* To avoid Time and Date being reset to factory default due
to drained battery, please fully charge the scanner for at
least 2 hours before use.
Example:
To change Data Format to
<Barcode Data>, <Quantity>, <Date>, <Time>
1. Scan [ Data Format ]
2. Scan [4], [5], [2], [3] on page 9.
3. Scan [
Data Format
]
The default Data Format is
<Date>, <Time>, <Barcode Data>
below are all items available for display and their codes:
. R011$
DATA FORMAT
2Date
Code Item Code Item
3
4
Time
5 Quantity
Barcode Data