Unitech MS912+ Quick Start Guide

- 3 -- 4 -
CHARGING THE BATTERY
1. Flip open the Type-C USB port on the scanner.
2. Insert the Type-C USB connector into the port on the
scanner and USB A connector into a USB port on
the host PC or a smartphone charger.
BEEPER INDICATION
LED INDICATION
Single long beep Power up
Single beep Good read
Single short beep The scanner reads a Code39 of
ASCII in configuration procedure
Two beeps i. Wireless connection
ii. The scanner successfully reads
a configuration barcode
Two short beeps Good read (Batch mode/Memory mode)
Several short beeps The scanner switches from one
communication mode to another
Off
Flashing Green
One Green Flash
Flashing Red
Solid Red
Standby or Power off
Disconnected or Discoverable
Good Read
Low power
Charging
GETTING STARTED
To scan a barcode, make sure the aiming beam fully
covers the barcode.
Four beeps (Hi-Lo-Hi-Lo) Out of range/Poor connection
Five beeps Low power
Three beeps Wireless disconnection
Three short beeps i. The scanner reads a barcodes
while disconnected.
ii. The scanner reads an unexpected
barcode during configuration
procedure. (scan [ABORT] to abort
and start over)


USB A
Host
Scanner
Type C

Unitech MS912+ Specifications

General

Brand	Unitech
Model	MS912+
Category	Barcode Reader
Language	English