Unitech PA600 Quick Reference Guide

Copyright 2008 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
Installing the Battery
1 Access the Battery Compartment by pushing the Battery Compartment cover
Latch in the direction of the arrow and up (A). Move the Backup Battery Switch
left to the ON position (B).
2 Position the Battery so
the Battery Contacts align
with the Battery Compart-
ment Contacts. Place the
Battery on top of the Plas-
tic Tab, as shown to the
right.
3 Simultaneously slide
the Battery Pack into
the Battery Compart-
ment while pulling the
Battery Hook until the
battery snaps into
place, as shown to the
right.
4 Replace the Battery
Compartment Cover.
Compartment Contacts
Plastic Battery Tab
Battery Hook
A
Backup Battery
Switch
B
Plastic Tab
Battery Hook
English

Unitech PA600 Specifications

System Memory

SDRAM memory	64 MB
Flash ROM	128 MB
Flash ROM with WWAN	320 MB

Display

display resolution	240x320 QVGA
display type	Color Transflective TFT
touch screen	Yes

Power

main battery	3.7V 1950mAh Li-Ion Battery Pack
backup battery	One Rechargeable Ni-MH Backup Battery
power source	Main Battery

Operating Environment

operating temperature	32ºF to 122ºF (0ºC to 50ºC)
storage temperature	-4ºF to 140ºF (-20ºC to 60ºC)
relative humidity	5% ~ 95% (non-condensing)

Weight and Dimensions

weight	290g with Battery & Scan Engine
length	149.5 mm
height	26.6 mm