EasyManua.ls Logo

Unitech UT-101 F - User Manual

Unitech UT-101 F
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
+91 94273 01436
Sales: Email :
www.unitechinstrument.com
Website:
“Sure for service with hi-end versal nology”Uni Tech
Sales@unitechinstrument.com
Add.-503/504,Helix Complex , Opp. Surya Hotel, Sayajigunj, Vadodra-05. Gujrat. INDIA, PH-0265 6623551
Model No. : UT-101 F
Model No. : UT-101 F
UNIVERSAL PROCESS INDICATOR / CONTROLLER
z
OPERATION MANUAL
z
AL-1
AL-2
CH-1
AL-1
AL-2
CH-1
C
O
M
A
L
-1
Question and Answer IconNeed help?

Do you have a question about the Unitech UT-101 F and is the answer not in the manual?

Unitech UT-101 F Specifications

General IconGeneral
Storage Temperature-20°C to 60°C
IP RatingIP54
CPU32 bit RISC microprocessor
Barcode ScannerLaser
PortsRS-232
Drop Specification1.2 m

Summary

Introduction

Front Panel Description

Front Panel Display Elements

Description of the Seven Segment LED display and indicator LEDs.

Front Panel Key Functions

Explanation of the function of each key on the front panel.

Technical Specification

Input and Signal Specifications

Details on input types, signal ranges, and transmitter power supply.

Performance and Output Specifications

Accuracy, impedance, control modes, and output types (Relay/SSR).

Communication and Programmable Parameters

Communication protocols, wireless options, and programmable settings.

Physical and Environmental Specifications

Dimensions, panel cutout, mounting, supply voltage, and operating conditions.

Installation

Terminal Arrangement

Description of terminal connections for supply, input, output, and communication.

Programming Flow Chart

Configuration Mode

Parameter and Relay Configuration

Covers password, input type, relay actions, decimal points, and dead band settings.

Communication Configuration

Configuration of Node Address and Baud Rate for communication.

Setup Mode

Display and Set Point Configuration

Setting zero/span values, set points, and hysteresis for relays.

Calibration Mode

Calibration Parameters

Covers password, zero calibration, and span calibration procedures.

Password Protected Parameter

Output Calibration Settings

How to set low and high calibration outputs.

Change Password Mode

Error Message and Troubleshooting

Register Address for Modbus RTU Protocol

Calibration Values

Related product manuals