Why is my UNITED UWM-7089 vibrating?
If your UNITED Washer vibrates, make sure that its feet are properly adjusted. Also, disassemble the safety stays used for transportation. Ensure that the machine isn't overloaded, and the laundry is evenly distributed. Prevent the machine from resting on hard surfaces.
What to do if my UNITED UWM-7089 Washer does not discharge water?
If your UNITED Washer does not discharge water, check if the discharging hose is clogged or twisted, and clean or untwist it. Also, clean the pump filter. Ensure that the laundry is spread evenly inside the machine.
How to reduce excessive foam in the detergent drawer of my UNITED Washer?
If you see excessive foam in the detergent drawer of your UNITED Washer, it might be due to using too much or the wrong type of detergent. Press the Start/Pause button, then mix a spoon of softener with half a liter of water and pour it into the detergent drawer. After 5-10 minutes, press Start/Pause again. Next time, use only detergents made for automatic washing machines and adjust the dose accordingly.
Why is my UNITED UWM-7089 not cleaning clothes properly?
If you're not satisfied with the washing results from your UNITED Washer, make sure the program you selected matches the contamination level of your clothes. Adjust the detergent amount based on how much laundry you have and how dirty it is. Avoid overloading the machine beyond its maximum capacity, and ensure your laundry is spread evenly.
What to do if my UNITED UWM-7089 Washer discharges water immediately after loading?
If your UNITED Washer immediately discharges water as soon as it's loaded, it's likely that the end of the water discharging hose is positioned too low. Adjust the height of the water discharging hose to the appropriate level.
How to remove detergent residues from clothes after washing in my UNITED UWM-7089 Washer?
If your laundries have detergent residues on them after washing in your UNITED Washer, it could be due to non-dissolving particles in some detergents that appear as white spots. Try running an extra rinsing cycle by setting your machine to the 'Rinsing' program. Alternatively, you can clean the spots with a brush after the laundries are dry.
Why do grey spots appear on laundries after washing in my UNITED UWM-7089?
If grey spots appear on laundries washed in your UNITED Washer, it may be due to oil, cream, or ointment. In your next wash, use the maximum amount of detergent recommended by the detergent manufacturer.
Why is the spinning operation not working or delayed in my UNITED UWM-7089?
If the spinning operation of your UNITED Washer is not performed or runs late, it may be because the unbalanced load control system has been activated. The system is trying to spread the laundries evenly. The wringing operation will begin after the laundry is spread. Next time, place the laundry in the machine in a balanced fashion.
What to do if the door of my UNITED UWM-7089 is left open?
Close the UNITED Washer door. If the machine continues to indicate a fault, turn it off, unplug it, and contact the nearest authorized service immediately.
What to do if the water pressure is low in my UNITED UWM-7089 Washer?
Turn on the faucet. If the problem persists, your UNITED Washer will stop automatically. Unplug your machine, turn off your faucet and contact the nearest authorized service.
To Next Page
General
