UNITED UWM-6108 - User Manual

Questions and Answers

S
Sharon MorrisAug 14, 2025
Why UNITED UWM-6108 machine doesn't start?
- S
  Savannah HendricksAug 14, 2025
  Your UNITED Washer machine might not start due to several reasons: * It might not be plugged in, so ensure it is properly connected to a power outlet. * The fuses could be faulty, requiring replacement. * There might be no mains power supply, so check the power source. * You may not have pressed the Start/Pause button, so press it to initiate the cycle. * The program dial might be in the 'stop' position; turn it to the desired program. * The machine door might not be completely closed; ensure it is securely shut.
M
Mr. David IngramAug 18, 2025
What to do if UNITED Washer machine does not intake water?
- D
  Dominic TuckerAug 18, 2025
  If your UNITED Washer machine isn't taking in water, here's what to check: * Ensure the water tap is turned on. * Inspect the water inlet hose for any twists and untwist it. * The water inlet hose could be clogged; clean the filters. * The inlet filters might be clogged, so clean them. * Make sure the machine door is completely closed.
N
nfosterAug 21, 2025
What to do if UNITED UWM-6108 Washer machine vibrates?
- J
  janet63Aug 21, 2025
  If your UNITED Washer machine is vibrating, consider the following: * The feet may not be adjusted properly, so adjust them to stabilize the machine. * Transit bolts used for transportation might still be fitted; remove them. * A small load in the drum can cause vibration, but this will not prevent operation of your machine. * The machine might be overloaded or the laundry is unevenly spread; avoid overloading and spread the laundry evenly. * The machine might be resting on a hard surface; avoid placing the washing machine on hard surfaces.
K
Kendra RileyAug 25, 2025
What to do if UNITED UWM-6108 Washer machine does not discharge water?
- A
  Amanda SnyderAug 25, 2025
  If your UNITED Washer machine isn't discharging water, try these solutions: * Inspect the drain hose for clogs or twists; clean or untwist it as needed. * Check the pump filter for clogs and clean it. * If laundry is packed too tightly, spread it evenly within the drum.
Z
zkirbyAug 27, 2025
Why is there excessive foam in the detergent drawer of my UNITED UWM-6108?
- B
  Bridget JenningsAug 27, 2025
  Excessive foam in the detergent drawer of your UNITED Washer is usually due to: * Using too much detergent. To stop the foam, press the Start/Pause button, dilute one tablespoon of softener into 1/2 litre of water and pour into the detergent drawer. Press the Start/Pause button again after 5-10 minutes. * Using the wrong type of detergent. Only use detergents specifically made for automatic washing machines.
T
Todd OlsenAug 31, 2025
Why UNITED UWM-6108 leaves detergent residue on laundry?
- P
  Pamela NunezAug 31, 2025
  If your UNITED Washer leaves detergent residue on your laundry, it's likely because non-dissolving particles from some detergents may appear as white spots. To resolve this, perform an extra rinse cycle, or clean your laundry with a brush after it dries.
J
Jennifer CoxSep 3, 2025
Why is the spin cycle delayed in my UNITED Washer?
- A
  Andres LewisSep 3, 2025
  If the spin cycle in your UNITED Washer is delayed, it is likely because the Unbalanced Load Control System has been activated. This system attempts to spread your laundry evenly. The spinning cycle will begin once your laundry is spread. For future washes, load the drum evenly.
D
Dr. Michelle SalinasSep 7, 2025
Why does UNITED UWM-6108 discharge water as soon as it is loaded?
- K
  Kyle BradleySep 7, 2025
  If your UNITED Washer discharges water as soon as it's loaded, it's likely because the end of the water drain hose is too low. Check that the drain hose is at a suitable height.
J
Janet WilliamsSep 12, 2025
Why do grey spots appear on laundry after washing in my UNITED Washer?
- J
  Jennifer SalazarSep 12, 2025
  If grey spots appear on your laundry after washing in your UNITED Washer, it's likely due to untreated oil, cream, or ointment on the items. For the next wash, use the amount of detergent as instructed on the packaging.