Unitron uDirect 2 Guide

5554
indicated on the uDirect 2 by the audio indicator
shortly blinking blue. A double-blink indicates
that two devices are connected to uDirect 2.
Deleting the pairing of Bluetooth devices
If you encounter issues with one of the paired
devices, or if a device stops connecting to your
uDirect 2, you may consider deleting the pairing
of devices to the uDirect 2.
1. Turn ON your uDirect 2.
2. Press and hold the (
) and ( ) buttons for
10 seconds until the blue rapid blinking audio
indicator stops.
Deleting the pairing of Bluetooth devices
removes the ability to connect to these devices.
You will need to perform the pairing process
again if you wish to reconnect.
pairing may vary for each device. Please refer to
the device’s user guide or dealer support if you
cannot complete the pairing procedure with the
generic steps described below.
1. Turn ON both your uDirect 2 and the other
device.
2. Place them next to each other.
3. Set your device into Bluetooth pairing mode.
4. Initiate the pairing process on your uDirect 2
by simultaneously pressing the (
) and ( )
buttons for 2 seconds until the audio
indicator is rapidly blinking blue.
5. Your uDirect 2 will remain in the pairing
mode for two minutes or until the pairing is
completed.
6. If a passcode is required, enter “0000” (four
zeros).
After pairing, wait until the devices have
completed connection.
Confirmation of successful connection is

Unitron uDirect 2 Specifications

General

Brand	Unitron
Model	uDirect 2
Category	Hearing Aid
Language	English