V200-18-E5B Snap-in I/O Module 3/05
4 Unitronics
Digital Outputs
Wiring Power Supplies
Use a 24VDC power supply for all digital
outputs.
1. Connect the "positive" lead
to the "V0" and "V1"
terminal, and the “negative”
lead to the common "0V"
terminal.
V0 provides the power supply for
Outputs #0, 1, 2, 3, 4, 5, 6, 7, and
8.
V1 provides the power supply for
Outputs #9, 10, 11, 12, 13, 14,
15, and 16.
In the event of voltage
fluctuations or non-conformity to
voltage power supply
specifications, connect the device
to a regulated power supply.
Transistor Outputs
Outputs 0 and 1 can function as either npn or pnp, in accordance with jumper settings and wiring. Open
the device and set the jumpers according to the instructions beginning on page 6.
Outputs 2 to 16 function as pnp only.
The 0V signal of the transistor outputs is isolated from the controller’s 0V signal.
npn (sink) pnp (source)
i4 Automation Ltd - 01480 395256
To Next Page
Loading...
