Unitronics V200-18-E5B - Analog Inputs

3/05 V200-18-E5B Snap-in I/O Module
Unitronics 5
pnp (source)
Analog Inputs
 Shields should be connected at the signal source.
 To set the inputs:
- Use the appropriate wiring as shown below.
- Open the device and set the jumpers according to the instructions beginning on page 6.
 Inputs may be wired to work with either current or voltage.
 All inputs share a common COM signal.
current current/voltage
i4 Automation Ltd - 01480 395256