Front Panel
__________________________________________________________
- 5 -
Note that the clock source can be independent of the signal used for digital to analog conversion.
For example, you could select AES/SPDIF as the clock source but perform D/A conversion on the
incoming ADAT optical signal by setting the Analog Outputs DAC Source Select knob ( see #6 on
page 7) to ADAT.
The 2192 sample rate is always determined by the Clock and Sample Rate Select knobs
except when the clock source is set to AES/SPDIF, in which case the sample rate of the
incoming signal is automatically detected and used.
The 2192 can be used for distribution of various clocks by connecting multiple clock
sources to the rear panel, then using the Clock knob to switch between them.
To Next Page
Loading...
Need help?
General
