Universal Laser Systems VLS2.30 - Page 31

7. After connecting the USB c o r d , the “ F ound New Hardware W izar d ” will open to install the drivers for the
USB connection. If the wizard offers to connect t o “ W indo ws Updat e ” to search for sof t w ar e, select “No,
not at this time . ” T hen select “ Nex t ” to c ontinue .
a. Select “Install the software automatically.” Then Select “Next” to continue. You do not need to insert
the Software Installation CD-ROM.
b. Select “Finish” to close the Wizard.
Note: Another set of New Hardware Wizard windows may appear after the initial USB connection.
Follow the same instructions as mentioned previously. Once completed your USB connection is
established.
31