SAFETY
Section 1-5
EU Compliance (CE)
Product Identification: X-660, X2-660, and SuperSpeed-660
Laser Engraving and Cutting Systems
Manufacturer: Universal Laser Systems, Inc.
16008 N. 81
st
St.
Scottsdale, AZ 85260
Phone: (480) 483-1214 Fax: (480) 483-5620
USA
This equipment Is manufactured in conformity with the following directives:
89/336/EEC (EMC Directive)
73/23/EEC (Low Voltage Directive)
98/37/EEC (Machinery Directive)
based on the standards listed.
Standards Used:
Safety:
EN 60950: 2002
EN 60825: 2001 (Class 3R)
EMC:
EN 55022: 2003 (Class A)
EN 50082-1: 1998
EN 61000-3-2: 2001 (class A)
EN 61000-3-3: 2002
EN 61000-4-2: 2001 (6kV CD, 8kV AD)
EN 61000-4-3: 2003 (3 V/m)
EN 61000-4-4: 2002 (2 kV power line, 0.5 kV signal line)
EN 61000-4-5: 2001 (class 2)
Note: This is not a declaration of conformity. The importer of this equipment
supplies the declaration of conformity.
LASER SYSTEMS INC.
Warning -
This is a Class A product. In a domestic environment, this product
may cause radio interference in which case the user may be required to take
adequate measures.
To Next Page
Loading...