Erasing All Learned Commands in ALL Components Erasing Macro Commands
STEP 1:
Press and hold both the
POWER ON and the STOP
buttons for 10 seconds, until the
display flashes ERASE ten times
STEP 2:
Release the buttons and the
display will flash SAVED twice
and the RF10 will automatically
return to normal operating mode
STEP 1:
Press and hold one of the
MACRO buttons (ON, OFF or one
of the 8 COMPONENT buttons)
and the MUTE button, until the
word “MACRO” is displayed on
the LCD screen.
IMPORTANT: You now have 30 seconds to
perform the next step while you are in
MACRO mode. If you don’t press a button
within 30 seconds, MACRO will disappear
from the screen, signaling that you have
exited erase mode and you will need to
start over.
STEP 2:
Press the CHANNEL ( ) UP
button to save. The display will
flash CLEAR and then SAVED
two times.
STOP
BUTTON
POWER ON
BUTTON
MACRO
BUTTONS
To Next Page
Loading...
Need help?
General
