Getting Started-Overview
This is what MASTERCONTROL™ RF10 is all about!
The RF10 is designed to operate up to 8 different
Audio/Video Components and is pre-programmed to
operate virtually all brands of TV, VCR, DVD and CD
Players, Cable Set Top Boxes, Satellite Receivers, TiVo
and other DVRs, Audio Components, Tape Decks,
Multimedia PCs, XM Radio, Ipod, X-Box, Lighting Controls
and other custom installation products. It also offers an
impressive lineup of special features designed to provide
you with many time-saving conveniences and enhance
your overall entertainment experience. However, we
strongly recommend that you fully complete all of the
Basic Setup steps before proceeding to customize your
RF10 with any of the special advanced features.
Battery Installation
The very first step is to insert
the four AAA batteries that
are included in the package
into the battery compartment
located in the back of the
remote. Just press the tab
and lift off the cover. Please
be sure to insert the batteries
correctly as you see in the
diagram. Remember, there
is a positive and negative
end to each battery and you
can tell by the + (positive) and
– (negative) symbols. Once
the batteries are correctly
installed, replace the cover.
Now you’re ready to start!
+
+
+
+
-
-
-
-
To Next Page
Loading...
Need help?
General
