universalblue SIROCO - Page 35

35
5. Remove the unthreaded
screw from the support
rod (F) and reserve. Also
remove the upper screw
in the hemisphere from
the support rod (F) and
the bar and reserve it.
6. Loosen the upper screw
from the lamp structure
(B) and loosen the lower
canopy screw (D).
7. Pass through the
support rod (F), the
upper canopy (E) and
the lower canopy (D).
Then run the cables
through the inside of the
support rod (F).
8. Fits the support rod (F)
into the lamp structure
(B). Replace the
unthreaded screw you
removed earlier and
tighten the lamp
structure (B).