PLATE UNITS - ASSEMBLY AND USE
CAUTION: Wear hand protection when working with these units.
THE ADJUSTABLE SLICER PLATE ASSEMBLY
To assemble the slicer plate, see Figure 6. When assembled, the plate can be adjusted to slice product
to different thicknesses by turning the adjusting nut as shown in figure 6.
PROPER ASSEMBLY OF THE SLICER PLATE ASSEMBLY
FIGURE 6
To tighten
Thrust bearing
Adjusting nut
To vary slice thickness
CAUTION: The thrust bearing must be securely tightened before the slicer plate assembly is loaded
into the housing. Failure to tighten the thrust bearing will damage the VS9 and the
VS2000 power unit.
NOTE: The thrust bearing requires a left hand twist to tighten.
WARNING: Adjustments for thickness must never be attempted while the VS2000 is under power or
severe personnel injury can occur.
Page 9
To Next Page
Loading...
