To Next PageTo Next PageWhat to do if the front housing of Univex VS2000 Kitchen Appliances will not shut tightly?
If the front housing doesn't shut tightly, it's likely the latch set screw is out of adjustment. You should adjust the set screw at the rear of the latch.
Why is the shredding plate loose or rattling on my Univex VS2000?
A shredding plate might be loose or rattling because it's not firmly shouldered on the hub pins, so inspect the shredder plate assembly. Another cause might be that the plate is bent, in which case you should replace it.
What to do if knife or plate scraping front housing in Univex VS2000?
If the knife or plate is scraping the front housing, it could be due to a loose thrust bearing, so you should tighten it. Alternatively, the lock pin might not be fully engaged; ensure it is properly engaged.
How to fix a mounted VS9 unit that rattles when under power in Univex VS2000?
If your mounted VS9 unit rattles when it's powered on, the thumb screw or securing mechanism is either missing or loose. You should tighten or replace these parts.
What to do if feed plate scraping plates in Univex Kitchen Appliances?
If the feed plate is scraping the plates, it probably means the feed plate is out of adjustment. Adjust the feed plate using the adjusting screw.
Why VS2000 power unit is under power but plate will not turn in Univex Kitchen Appliances?
The VS2000 power unit might be on, but the plate won't turn if the PTO adapter is missing from the power take-off assembly. Replace the PTO adapter to solve this.
General| Brand | Univex |
|---|---|
| Model | VS2000 |
| Category | Kitchen Appliances |
| Language | English |
