English
BakerTop
™
ChefTop
™
5
The display 1 (STEP) shows number 1.
To activate the data storing (cooking chamber and core probe temperatures of the connected appliances)
connect the USB memory to the bridge connector.
It is possible to set the time interval between the records and select the appliances you need to record
the temperatures values.
To set the time interval between the records push the “SELECT” button: the time icon starts to flash
and the display 2 (time) shows the time interval value; by pushing the “+” and “-“ buttons you can set the time
value. The time is indicated in MINUTES.SECONDS (3.45 means a record every 3 minutes and 45 seconds).
This value can be set between a minimum of 30” and a maximum of 9’59”.
Once the interval time value has been set, push again the “SELECT” button: the chamber and Delta T
temperatures icons start to flash and the display 3 shows the appliance of which the temperatures values
will be recorded (chamber and core probe if any): by pushing the “+” and “-“ buttons you can select
the required appliance; when the message “ALL” is shown, the temperatures values of all the connected
appliances will be recorded.
If no button is pushed, after 4 seconds the icons stop to flash.
To start the recording push the “START/STOP” button: the led indicating the temperatures recording
is running turns on.
By keeping the “START/STOP” button pusher for 2” the recording stops and the led turns off.
Attention!
Do not remove the USB memory while the recording is running otherwise the data so far recorded will
be missed.
Data storing
To Next Page
Loading...
Need help?
General