EasyManuals Logo

UPPAbaby mesa Instruction Book

UPPAbaby mesa
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
4 5 UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book
Please register your child restraint by lling out and
sending the postage-paid registration card that came
with your child restraint OR register online at:
uppababy.com/ca/register.
Child restraints can be recalled for a variety of safety reasons. You must
register this restraint to be reached in a recall.
For recall information, call Transport Canada’s Motor Vehicle Safety
Centre at 1-800-333-0371 or go online to tc.gc.ca/eng/
motorvehiclesafety/safedrivers-childsafety-notices-menu-907.htm.
TAKE A MOMENT TO FILL OUT THE FOLLOWING INFORMATION:
Information can be found on the manufacture labels or engraved on the
underside of the carrier.
Model Name: MESA / Model Number: 1017-MSA-CA
Serial Number: Date of Purchase:
REGISTRATION
Discontinue use of this
child restraint after 7
years from the date of
manufacture or after a
crash. Refer to labels
on bottom of Infant
Carrier and Base.
NOTICE OF EXPIRATION
CARRIER BASE
BEFORE YOU BEGIN
USE RECOMMENDATIONS
Children should remain rear-facing for as long as possible.
UPPAbaby
along with pediatricians and child passenger safety advocates
advise parents to keep their toddlers in rear-facing car seats until age 2,
or until they reach maximum height and weight for their seat. Do not use
this child restraint beyond the expiration date or if the child outgrows
either the weight or height requirements.
This child restraint is for use by children who meet BOTH requirements below:
WEIGHT REQUIREMENTS: 1.8-15.9 kg (4-35 lbs) Includes Infant Insert
recommended for use with infants weighing 1.8-3.6 kg (4-8 lbs)
HEIGHT REQUIREMENTS: 81.3 cm (32 in) or less
The top of the child’s
head should not be less
than 25 mm (1 in) from
the top of the headrest
when in its highest
position.
Harness should be
at the shoulders or
slightly below.
Retainer clip must be
at armpit level
and
harness straps should
be snug
.
25 mm
BEFORE YOU BEGIN

Other manuals for UPPAbaby mesa

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the UPPAbaby mesa and is the answer not in the manual?

UPPAbaby mesa Specifications

General IconGeneral
Product TypeInfant Car Seat
Car Seat Weight Without Base9.9 lbs
Child Maximum Height32 inches
InstallationLATCH or seat belt
Harness Type5-point
Safety StandardsFMVSS 213
CompatibilityCompatible with UPPAbaby strollers

Related product manuals