Upright SB85J - Prestart Inspection Checklist

Chapter 7 – Prestart Inspection
SB85J Fixed Axle – 0112975 39
Item Inspect For Ok
Operator’s Manual In manual holder
Engine
Oil level Between full and add marks
Coolant Liquid cooled engines-proper fluid level
Air cooled engines-air intake and fan free
of obstructions/belt in good condition
Radiator Cap tight, good condition and clean
Fuel tank and line Tank full, cap in place and tight/no leaks
Air filter Green indicator
Charging system Proper operation
Cold weather start kit No damage or deformation
Electrical System
Batteries Condition and charged for proper operation
Battery fluid level and terminals Proper level/clean, connectors tight
Cables and wiring harness No wear or physical damage
Hydraulic System
Fluid level Between full and add marks
Fluid filter Verify operation in the green zone
Hoses, tubes, and fittings No leaks
Cold weather warm-up kit Proper operation
Tires and Wheels Good condition
Lower Control Station
Operating controls Proper operation
Emergency stop and emergency power Shuts off lower controls/proper operation
Emergency Lowering Proper operation
Level Sensor Sounds tilt alarm
Flashing Light Proper operation
Sandblast Protection Kit In place and proper operation
Structures
Weldments Welds intact, no damage or deformation
Slide pads In place, no damage or deformation
Fasteners In place and tight
Wire ropes No deformation or broken strands
Whiffles Parallel to boom edge
Belleville washers Compressed with no gaps
Upper Control Station
Guardrail system and lanyard anchors Welds intact, no damage or deformation
Operating controls Proper operation
Emergency stop and emergency power Shuts off upper controls/proper operation
Horn Sounds when activated
Electrical power outlet Proper operation
Drive motion alarm Sounds when aerial platform moves
Driving and work lights Proper operation
Platform control cover In place and proper operation
Placards and Decals In place and readable
Prestart Inspection Checklist