To Next PageTo Next Page
Need help?Do you have a question about the Upright X26N and is the answer not in the manual?
General| Platform Capacity | 230 kg |
|---|---|
| Weight | 1340 kg |
| Platform Height | 6.1 m |
| Drive Type | Electric |
| Maximum Working Height | 8.1 m |
| Dimensions (L x W x H) | 2.48 m x 0.99 m x 2.26 m |
| Working Height | 8.1 m |
| Overall Width | 0.99 m |
| Overall Length | 2.48 m |
| Maximum Load Capacity | 230 kg |
| Lifting Height | 6.1 m |
NEVER operate the machine within ten (10) feet of power lines. THIS MACHINE IS NOT INSULATED.
NEVER operate the boom or drive with the platform elevated unless on firm, level surface.
NEVER position the machine without first checking for overhead obstructions or other hazards.
NEVER climb, stand or sit on the platform guardrails or midrail.
Identifies and explains the controls located on the chassis of the machine.
Identifies and explains the controls located on the platform.
Instructions for extending and retracting the platform.
Procedures for moving the machine with the platform in the lowered position.
How to operate the steering system of the machine.
Steps to safely raise the platform to the desired height.
Guidance on moving the machine while the platform is raised.
Procedure for safely bringing the platform back to the ground.
How to lower the platform in an emergency situation.
Procedures for lowering and raising guardrails on specific models.
Procedures for lowering and raising guardrails on specific models.
Instructions for folding down and erecting guardrails on the X31N model.
Steps to release the parking brake for specific situations.
How to properly engage the parking brake after use or transport.
Daily shutdown and securing procedures for the machine.
Safety instructions for lifting the machine with a crane.
Guidelines for safely moving the machine using a forklift.
Procedures for loading the machine onto transport vehicles.
Method for safely blocking the elevating assembly during maintenance.
Steps for installing the scissor brace for support.
Instructions for stowing the scissor brace after use.
Information about the machine's level sensor.
Procedure to test the functionality of the level sensor.
Guidance on checking and maintaining hydraulic fluid levels.
Specific steps to check the hydraulic fluid level.
Important precautions and checks for battery maintenance.
Procedure for charging the machine's batteries.
A checklist for daily inspection and maintenance tasks.
Explanation of symbols used in the maintenance table.
Section for recording maintenance activities.
