13
4.0 SETTING UP THE HN3000
The HN3000 time clock allows users to punch in and out
with paper time cards. Before the employees can begin
punching, the administrator must set up the time clock for
use.
To get started, plug the time clock into a surge protector
or uninterruptible power supply (UPS). Then remove the
cover of the time clock using the enclosed key. You will
now be able to access the buttons and switches.
4.1 Overview of the HN3000
The IN and OUT buttons on the keypad will be used later
for punching in and out. These buttons are also used in the
setup of the clock. Once you have removed the cover, you
will see labels for the buttons. You will also have access to
the Set and Battery switches, which are located beneath
the labels.
The following switches and buttons can be found on the
HN3000 time clock keypad.
Set -/0
+ Enter Back Clear Mode
Battery
ResetON-OFF
—
To Next Page
Loading...
