uPunch HN4000 - Changing the Settings in the HN3000

14
Switch Function
SET
Enter and exit the setup mode (- /
0). When the Set switch is pushed
to the left (–), the clock is ready for
punching. When the Set switch is
pushed to the right (0), the clock
is in the setup mode and you can
begin setting up the menus.
BATTERY Turns on/off the battery (left/right).
NOTE: To charge the battery, the switch must be set to the
OFF position. The backlight on the display screen is not
enabled if the time clock is in battery mode.
Button Function
+ Increase value
- Decrease value
ENTER Conrm set value
BACK Backspace the set value
CLEAR Cancel the set value
RESET Restart the time clock
MODE Advance to the next menu
4.2 Changing the Settings in the HN3000
To access the menu options on your time clock, remove
the cover of the clock using the enclosed key. Then move
the Set switch to the “0” position (to the right).