uPunch HN4000 - HN2-Pay Period Settings

34
Setting the Hour and Minute of the end of Daylight
Savings Time (code 07)
When the code “07” appears, set the hour and
minute of the end of Daylight Savings Time (hh:mm)
to 2:00am. Use the + and – buttons to make your
selection, then press Enter to conrm the setting.
HN2—Pay Period Settings
The HN2 menu allows you to program the following
features.
Setting the Day Change Time (code 00)
Under the HN2 menu, when the code “00” appears,
set the time at which the day changes (hour/minute).
Use the + and – buttons to make your selection, then
press Enter to conrm the setting.
Setting the Pay Period (code 01)
When the code “01” appears, set the pay period you
would like to use. The options are:
1 Monthly—Select 01 for the Monthly option, then
select the date on which the pay period will start.
2 Weekly—Select 02 for the Weekly option, then
select the day on which the pay period will
start. Enter 00 for Sunday, 01 for Monday, 02 for
Tuesday, 03 for Wednesday, 04 for Thursday, 05
for Friday, or 06 for Saturday.
3 Bi-weekly—Select 03 for the Bi-weekly option,
then select the month and date on which the rst
pay period started. Enter 01 for January, 02 for
February, and so on.
4 Semi-monthly—Select 04 for the Semi-monthly
option, then select the rst payday. Enter 01 for
the paydays to occur on the 1st and 16th of the
month or enter 15 for the paydays to occur on the
15th and the last day of the month.