12
5-1: A manual program, including normal mode (manual mode), time countdown, distance
countdown, and calorie countdown.
5-2: 12-speed program: P1, P2, P3, P4, P5, P6...P11, P12.
5-3: Entering the manual mode:
a: Turn on the power switch to directly enter the normal mode (manual mode).
b: In stop mode, press this key to enter the normal mode (manual mode).
c: Three functions in manual mode: time setting, distance setting, and calorie setting.
• When you start to enter the manual mode, it is in the normal mode first, and all parameters
are initial values.
• In manual (normal) mode, press the Mode key to enter the time countdown mode. 30:00
displays and flashes on the time bar. Press the speed "+" or "-" key to set the countdown
time. The setting range of time is 5: 00-99: 00.
• In time countdown mode, press the Mode key to enter the distance countdown mode.
1.0 displays and flashes on the distance bar. Press the speed "+" or "-" key to set the
countdown distance between 1.0-999.9 (km).
• In distance countdown mode, press the Mode key to enter the calorie countdown mode. 50
displays and flashes on the calorie bar. Press the speed "+" or "-" key to set the countdown
calorie between 20-999 (kcal).
5-4: Operation in manual mode:
a. Press the Start key and the motor starts to run.
b. Press the speed "+" or "-" key to adjust the speed.
c. Press the Stop key and the speed slowly decreases until it stops;
d. When the set time decreases to zero, the speed slowly decreases until it stops.
e. When the set distance decreases to zero, the speed slowly decreases until it stops.
f. When the set calorie decreases to zero, the speed slowly decreases until it stops.
5. Description of programs
6. Programs
6-1: The initial time is set to 30 minutes. You can only set time within 5:00-99:00. Press the
speed "+" or "-" key to adjust the set value.
6-2: Press START to start the motor at the speed set in the program.
6-3: Press the speed "+" or "-" key to adjust the speed.
6-4: Each program is divided into 16 segments, where the running time is 1/16 of the set time.
6-5: A beep sounds when switching between segments.
6-6: When the set time decreases to zero, the speed slowly decreases until it stops.
7. Safety lock
In any mode, pull off the safety lock, the window displays "E -7" and the buzzer sounds bi-bi-bi.
If the motor is running, it will stop immediately. At this time, no operations can be performed on
the treadmill except shutting down. When the safety lock is correctly installed, the treadmill
will enter the standby state again and wait for instructions.
DASHBOARD OPERATION
To Next Page
Loading...
