Situations 1：The running belt has been adjusted before shipment, but it would be stretched
and its center position would deviate from the original position after use causing
damage to the foot edge strips and rear cover due to rubbing. It is normal that
the running belt is stretched during use.
Situations 2：If the running belt slips or does not run smoothly when you use the treadmill,
you can adjust the tightness of the running belt.
The following two situations need to adjust the running belt
Adjust the position of the running belt:
ADJUSTMENT OF RUNNING BELT
When you are running on the treadmill, the pressure on the running belt is imbalanced as the
force applied by your feet on the belt is different, which will deviate the running belt from the
center. Such deviation is normal and the running belt will return to the middle if no one runs
on it. If it is not centered, you need to adjust the running belt until it moves to the middle.
1.Allow the treadmill to run with no load and adjust the speed to 12km/h.
2.Observe the distance between the running belt and the left and right edge strips.
• If it moves to the left, use the hexagon wrench to rotate the left screw by 1/4 turn
clockwise.
• If it moves to the right, use the hexagon wrench to rotate the right screw by 1/4 turn
clockwise.
• If the running belt is still not centered, repeat the above operation until it moves to the
middle.
3.When the running belt is in the middle, adjust the speed to 12km/h, and observe the
deviation and smoothness of the running belt. If there is a deviation, repeat the adjustment
steps. Warning! Do not tighten the rollers too much. This will result in permanent damage to
the bearings.
If the above operations are not effective, you need to tighten the running belt a little more.
15
To Next Page
Loading...
